|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||||
|
||||||
|
Here are the specs (all at 12 Volts) from past years:
Van Door Motor (Tiagene): 75 RPM No Load Speed, Stall Torque 37 Nm Clockwise, 34 Nm Counter-Clockwise, Stall Current 40 Amps. That's everything you need (except no-load current, which is probably a couple tenths of an amp) to plot the torque, current, power and efficiency curves. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Attn Wildstang: Found your van | Wetzel | Chit-Chat | 4 | 21-04-2003 21:41 |
| Backdrive disable for the van door motors? | archiver | 2001 | 9 | 24-06-2002 01:04 |
| Looking for van door motors... | archiver | 2000 | 1 | 23-06-2002 23:48 |
| We can't compete, need van door motor | archiver | 2000 | 1 | 23-06-2002 22:59 |
| van door question | archiver | 2000 | 1 | 23-06-2002 22:27 |