|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#15
|
|||||
|
|||||
|
Check out my thread in the "MOTORS" area
![]() I was checking out the drill motor this morning and the exact same thing happened...it just somehow slipped out of my hand, rolled onto the table, and then fell onto the floor, resulting in one of the contacts falling off and the flimsy piece of plastic holding it there snapping off Then I had to go tell my staff advisor what I happened ![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| drill motor mounts- again | Jeff Sharpe | Motors | 6 | 07-04-2003 23:20 |
| drill motor mounting | whynot | Technical Discussion | 3 | 03-02-2003 08:24 |
| External metal jacket on the Drill motor and FP motor, WHY? | archiver | 2001 | 3 | 24-06-2002 04:22 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| Drill Motor and FP Motor Shaft Diameters | Andy Baker | Motors | 4 | 11-06-2001 20:12 |