|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#22
|
||||||
|
||||||
|
One of the rookie teams we are mentoring had something similar happen. When we were opening the drill motor box, there were very small plastic shards in the packaging. Seeing them was my first clue that something bad was lurking within. The whole brush assembly popped out when I picked up the motor because one of the mounts for the brushes was broken.
Sorry Al, nobody had a camera so no pictures. Since it wasn't dropped by us I had them call FIRST and see about a new motor. I haven't heard what came of it yet though. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| drill motor mounts- again | Jeff Sharpe | Motors | 6 | 07-04-2003 23:20 |
| drill motor mounting | whynot | Technical Discussion | 3 | 03-02-2003 08:24 |
| External metal jacket on the Drill motor and FP motor, WHY? | archiver | 2001 | 3 | 24-06-2002 04:22 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| Drill Motor and FP Motor Shaft Diameters | Andy Baker | Motors | 4 | 11-06-2001 20:12 |