|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
||||
|
||||
|
I really can't tell you. One loop through the code is at minimum 26ms. What it is for you is different. Any change to your code will lenghten or make your loop time smaller. If you are trying to make a timer then check here.
Hope this helps. [edit] Sorry. The other post wasn't here when I went to reply[/edit] |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Threads getting too long to make sense of | Ken Leung | CD Forum Support | 22 | 05-05-2005 01:14 |
| Impending BASIC Stamp Editor Beta 2 release | Greg Ross | Programming | 9 | 19-09-2003 06:05 |
| Actual execution time measurement | Dan | Technical Discussion | 5 | 24-03-2003 11:36 |
| Problem with communicating with STAMP through serial port | Skabana159 | Technical Discussion | 2 | 06-02-2003 21:10 |
| How long should production time be??? | archiver | 1999 | 4 | 23-06-2002 23:16 |