|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||
|
|||
|
Ugh.. okay... Um... I have a little question that may be hard to answer... Our team is trying to get longer left handed thread screw, but we need the specs for the screw so we can go get it. We checked the manuals in the kit, etc... If you have the specs or know where to find them, please PM me. Thanks.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cutting the output shaft | Kevin A | Technical Discussion | 2 | 18-02-2003 01:47 |
| Can I drill the output shafts of unmodifiable motors? | archiver | 2001 | 4 | 23-06-2002 23:08 |
| drill motor drive shaft attachment | archiver | 2001 | 1 | 23-06-2002 22:32 |
| using set screw or dowel pin/pin to hold on drill motor coupler thinggy | Travis Covington | Motors | 1 | 04-02-2002 03:02 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |