|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
|
|||||
|
|||||
|
What we did last year when we needed to do things like that, we walked into a Brafasco, showev them the part, and say we a longer one of this.
Brafasco is basically the Wal-Mart of fastners of ANY KIND. I don't know if you have them in the US, but if you do, look them up. And even if you don't have them, I'm sure you have things like them. http://www.brafasco.com |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cutting the output shaft | Kevin A | Technical Discussion | 2 | 18-02-2003 01:47 |
| Can I drill the output shafts of unmodifiable motors? | archiver | 2001 | 4 | 23-06-2002 23:08 |
| drill motor drive shaft attachment | archiver | 2001 | 1 | 23-06-2002 22:32 |
| using set screw or dowel pin/pin to hold on drill motor coupler thinggy | Travis Covington | Motors | 1 | 04-02-2002 03:02 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |