|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
I woudl say the best and simplist way is to just move the box and the arm at the same time, if you need to pivot, go to hierachy and adjust the pivot points of all the objects to be in the place that you want it to be in.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| box orientation | Lance | General Forum | 1 | 13-02-2003 10:12 |
| project box | archiver | 2000 | 2 | 23-06-2002 23:01 |
| Gray box limitations | Tim Skloss | Technical Discussion | 1 | 23-01-2002 07:38 |
| Modular Control box assembly | Andrew Wyatt | Technical Discussion | 4 | 29-11-2001 15:44 |
| power of globe motor with gear box? | Ken Leung | Motors | 5 | 21-11-2001 13:43 |