|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
||||
|
||||
|
To hook up your RC to a computer to program, you place a serial cable in the "Program" Port (next to the tether and radio ports). Hook the other end into a COM port on your computer and tell your PBASIC editor to recognize the COM.
Good Luck ![]() Last edited by DaveG702 : 29-01-2003 at 17:46. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| My computer loves Microsoft ARGH!! HELP ME! | team222badbrad | Chit-Chat | 12 | 29-01-2005 09:17 |
| serious problem found - robot controller resets when jarred! | KenWittlief | Electrical | 23 | 19-03-2003 13:30 |
| List of UTC Hartford Teams | archiver | 2001 | 3 | 24-06-2002 01:09 |
| Full list of teams & competitions | archiver | 2001 | 14 | 24-06-2002 00:52 |
| hooking up sensors to controller? | Oakridege_665 | Technical Discussion | 5 | 21-01-2002 14:55 |