|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
|
|||
|
|||
|
Bobcat Kits?
Thanks for the quick response, Andy. You're right about the crimping tool being so expensive. Maybe I can trade in a few of those FIRST crimpers we get with the kit.
Speaking of #177, I was most impressed with the motor mounts on the Bobcat. They looked like modified connector plates so you could mount the motors any where you wanted. P.J., any hopes of publishing the details of the drill motor mounts? I think this would complement #45's design from last year. -Jason |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Let's get some aluminum extrusions | archiver | 1999 | 3 | 23-06-2002 23:12 |
| Legal fastener for aluminum structural framing question. | archiver | 2000 | 8 | 23-06-2002 22:44 |