|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
|
||||
|
||||
|
Thanks for all the replies! I think I have something awesome figured out. I will post here when I have more questions.
Thanks again Edit: I found this code that deals with the byte, but I don't quite understand it. code: get AUTON_PROG_NUM, temp10 out8 = temp10.bit0 out9 = temp10.bit1 out10 = temp10.bit2 out11 = temp10.bit3 out12 = temp10.bit4 out13 = temp10.bit5 out14 = temp10.bit6 out15 = temp10.bit7 How would I go about assigning values to each bit? Is the get command necessary? What is it for? Last edited by Jeff_Rice : 27-04-2003 at 21:52. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Custom dashboard program available. Interest? | archiver | 2001 | 4 | 24-06-2002 00:45 |
| Need help in creating program to use servo's to shift drive | archiver | 2001 | 19 | 24-06-2002 00:35 |
| miroboworks dashboard program? | archiver | 2000 | 3 | 23-06-2002 23:04 |
| CCISD Updated Dashboard program v2.2.1 | archiver | 2000 | 3 | 23-06-2002 21:57 |
| Yet another dashboard program | Neal Probert | Programming | 3 | 12-05-2002 10:43 |