|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
|
||||
|
||||
|
here are the pinouts for port 3:
(PIN) (2) Joystick Trigger Switch Digital (bit) p3_sw_trig Relay 3 Forward SW05 [5] (7) Joystick Thumb Switch Digital (bit) p3_sw_top Relay 3 Reverse SW06 [5] (10) Aux Switch1 Digital (bit) p3_sw_aux1 Relay 6 Forward SW07 [5] (14) Aux Switch2 Digital (bit) p3_sw_aux2 Relay 6 Reverse SW08 [5] pin 4 and 12 are grounds so if you want p3_sw_aux1 in the code (for example) to be 1, you wire a switch from pin 4(or 12) to pin 10 which is the imput, so basically for a switch to work you wire it from the pin you want to the switch then the switch to ground so pin 10 on oi----->switch------->ground / --------------------------------- | | | The Switch | | (SPST) ] ___________________ | | pin 10 ground _______________________________________ and check out the control system manual at: MANUAL page14-17 has the pin-outs for the others ______________ hope this helps ![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need help with custom switches | archiver | 2001 | 3 | 24-06-2002 00:35 |
| Wiring Switches To the Operator Intrerface | archiver | 2000 | 2 | 23-06-2002 23:02 |
| So what's in YOUR Custom Circuit this year? | kmcclary | Technical Discussion | 7 | 10-04-2002 12:20 |