|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
||||||
|
||||||
|
Enlarged Metric 2.0 Module Gear...
Jideco would not / could not provide gear data.
By reverse engineering, I have convinced myself that it is a metric module 2.0 gear with a 20 degree pressure angle. It is enlarged, but how much, I don't know. I had our shop measure a couple of standard gears mating with the pinion as best as we could measure it without an elaborate set up. That data is the data that FIRST put on the print they published. The engineer that is using the motor on our mechanism thinks something is goofy about my data, but is not sure exactly which point he distrusts. I think that for most applications if you just add about .4mm to the theoretical center distance, things will work out just fine. Probably more information than you wanted, but there it is just the same. Joe J. Last edited by Joe Johnson : 30-01-2002 at 10:04. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking for practice motors & extra tape drive parts? | archiver | 2000 | 1 | 23-06-2002 22:54 |
| Suppose you want seat motors... | archiver | 2000 | 0 | 23-06-2002 22:50 |
| Jideco motors wanted for trade | RobZeuge | Technical Discussion | 6 | 20-02-2002 16:44 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| Drill Motors | TF8 | Motors | 19 | 12-12-2001 13:13 |