|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#15
|
||||
|
||||
|
Re: Using an Operator Interface with the 2004 EDU RC wirelessly
Joe,
I am still a little confused on your set-up. What are you using for the modem on the 2003 EduRC? For your test, plug the servo into pwm08 and test with py_4, this is a direct link. The setup that we are using is as follows: 2003 OI with its Radio Modem, Team Number set (ours is 716) per IFI instructions. 2003 EduRC with its interal modem (this is the black box with two sets of multiple pins and plugs into the bottom of the motherboard) and motherboard, Team number set to 716, switch set to 'program'. Do not use the full size RC radio modem. I think you are using the internal modem because you said you had no problem programming. 2004 EduRC Cable between the 9 pin connectors of the EduRC's. Note- must be per this thread, note crossover between pins 2 and 3. Do not use a standard serial cable! All pwm cables attached to 2004 EduRC. Good Luck! Andy Brockway Team 716, The Who'sCTEKS Last edited by Andy Brockway : 08-12-2003 at 08:04. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| My hints and guess on the Game in 2004! | Elgin Clock | Rumor Mill | 116 | 09-01-2004 13:30 |
| 2004 Championship Eligibility Criteria!!! | dez250 | General Forum | 214 | 28-12-2003 20:11 |
| 2004 will be 2 v 2 | Gadget470 | Rumor Mill | 20 | 25-10-2003 21:32 |
| 2004 Goals | Rich Kressly | FIRST Interactive Rural SupporT | 2 | 19-10-2003 18:09 |
| 2004 OCCRA Competition | Gadget470 | OCCRA | 2 | 11-06-2003 12:37 |