|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
After downloading a new program to the controller, you need to reset your robot controller (pushing the "robot reset" button will do, as well as simply turning the robot off then back on again).
Also, One of the programmers on our team was using a laptop with Windows 2000 to program the robot. We had to disconnect the cable from the program port when we wanted to run the new program. On a Windows 98/95 system, disconnecting hasn't been necessary. (I don't know what would happen if we tried Windows Me, or XP) |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Impending BASIC Stamp Editor Beta 2 release | Greg Ross | Programming | 9 | 19-09-2003 06:05 |
| Basic Run Error | BBFIRSTCHICK | Programming | 10 | 02-04-2003 22:43 |
| Basic Init Error | yan184 | Programming | 5 | 14-12-2002 13:10 |
| Basic Run Error | Ulibrium | Programming | 12 | 21-02-2002 01:02 |
| BASIC Stamp Error | mpatterson | Programming | 4 | 22-01-2002 12:08 |