|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||
|
|||
|
What type of spec?
Posted by Joe Johnson.   [PICTURE: SAME | NEW | HELP]
Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems. Posted on 1/16/2000 8:08 AM MST In Reply to: Specs for drill motor gearbox? posted by Eric on 1/15/2000 9:29 PM MST: Eric, What spec do you want? I can tell you that the I think the drill spec claims that the drill can provide 250 in-lbs of torque. The ratio in low gear is about 60 to 1 and the ratio in high gear is about 20 to 1. All that the info (probably more accuately reproduced) in in the manual. Good Luck, Joe J. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Q&A Discuss: Are specs available on the new motors/mounts? | CD47-Bot | Extra Discussion | 3 | 15-01-2003 19:39 |
| Are specs available on the new motors/mounts? | MattB703 | Motors | 2 | 06-01-2003 09:26 |
| motor specs? | Gary Dillard | Motors | 0 | 04-01-2003 17:54 |
| On-board chip spec's | archiver | 2000 | 4 | 23-06-2002 21:55 |
| Motor specs | kmcclary | Off-Season Events | 4 | 26-10-2001 22:41 |