|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#6
|
|||
|
|||
|
Re: Programming
Posted by Jerry Eckert.
Engineer from Looking for a team in Raleigh, NC sponsored by . Posted on 1/31/2000 9:59 AM MST In Reply to: Programming posted by Justin Stiltner on 1/30/2000 10:53 PM MST: : I hope sombody knows how to accomplish this : I need to be able to control a pwm with a button and a joystick, specifically I need to be able to move the joystick and have the motor respond normally but when the top button is pressed the motor should go to full speed in whatever direction the joystick is in or foward if the joystick is centered : I think I have figured out how to do this but I wont get to find out untill tomarrow. : also what is the function and what does each part of the serout command mean?? Try this: IF (p1_sw_top = 0) then skip_full_drive LOOKDOWN drive, |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming Compatition | Angela06 | Programming | 30 | 08-04-2005 23:12 |
| multi-bank programming problem | GregC | Programming | 3 | 14-02-2003 16:13 |
| Pneumatics electrical wiring and programming | archiver | 2001 | 1 | 23-06-2002 23:10 |
| Error found in programming for the pump and pressure switch | sjharobotics | Programming | 4 | 06-02-2002 17:46 |
| pbasic programming | punarhero | Programming | 4 | 21-01-2002 23:32 |