|
How is our gear ratio?
Posted by nuts4first.
Engineer on team #340, GRR - Greater Rochester Robotics, from Churchville-Chili and Nortel Networks.
Posted on 2/23/2000 1:27 PM MST
In Reply to: Drill Motors are pretty tough... posted by Joe Johnson on 2/22/2000 7:33 PM MST:
Is a 15 (on the drill axle) to 18 (on the wheel) gear ratio bad? We are locked in low gear and driving 2-6' wheels with each motor. Our robot weights 130 lbs. I've tried to use some of the speadsheets, but I'm not sure now to read them.
What does everyone think?
-Team 340
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|