|
|
|
![]() |
|
|||||||
|
||||||||
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
hieght of the scoring ramp
Posted by Pat.
Student on team #101, STRIKER, from St. Patrick High School and LoDan Electrtonics. Posted on 10/17/2000 9:59 AM MST In the diagram of the scoring ramp, they do not asign a measurement to the height of the back. Does anybody know the angle of the ramp. If so, please respond. |
|
#2
|
|||
|
|||
|
Re: hieght of the scoring ramp
Posted by Nate Smith.
Other on team #66, GM Powertrain/Willow Run HS, from Eastern Michigan University and GM Powertrain. Posted on 10/17/2000 12:47 PM MST In Reply to: hieght of the scoring ramp posted by Pat on 10/17/2000 9:59 AM MST: : In the diagram of the scoring ramp, they do not asign a measurement to the height of the back. Does anybody know the angle of the ramp. If so, please respond. The height of the peak is approx. 6 inches, according to one of Joe's posts earlier today...linked to below. Also, the angled surface of the ramp is made of a 48x48 piece of plywood(again from Joe's post). This should give you the information you need to calculate the angle. Hope this helps... Nate |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Robot/Goal scoring: Official Answer Mike Martus | Mike Martus | OCCRA | 6 | 21-10-2003 23:51 |
| A question about scoring.. Stack hieght... | mike325 | General Forum | 7 | 09-01-2003 09:30 |
| Pulling robot off ramp legal? | archiver | 2000 | 2 | 24-06-2002 00:14 |
| scoring ramp dimensions | archiver | 2000 | 3 | 24-06-2002 00:13 |
| Technical question about ramp balancing | archiver | 2001 | 5 | 23-06-2002 22:29 |