|
Re: yes and no...
Posted by Raul.   [PICTURE: SAME | NEW | HELP]
Engineer on team #111, Wildstang, from Rolling Meadows & Wheeling HS and Motorola.
Posted on 10/18/2000 4:02 PM MST
In Reply to: yes and no... posted by Joe Johnson on 10/18/2000 12:03 PM MST:
: Yes you can, IF you don't use forbidden methods (e.g. a mill or a lathe) to manufacture it.
I don't mean to push the boundaries of precision machining too much but:
1) Are we allowed to use an indexing head or any other precision fixtures along with a drill press?
2) If not, are we allowed to make a fixture out of legal materials using mills, etc?
Raul
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|