|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
|
|||
|
|||
|
i repeat the "i am a ninny" phrase... :)
Posted by Anton Abaya at 1/25/2001 10:30 PM EST
Coach on team #419, Rambots, from UMass Boston / BC High and NONE AT THE MOMENT! .In Reply to: So...Dump Small Parts Suggestion? Posted by Eric Reed on 1/25/2001 2:09 PM EST: : So, is the general consensus that we should NOT use the 1/8" dowel provided by Small Parts? Any teams try this yet? : Eric - 481 i guess i need more experience with these set screws... good info to know considering we were planning to screw the pins and go with the screws (did i confuse u there? ) hehe... welll, we'll see what happens... set screws=bad, pins=good? am i getting it? -anton |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|