|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
|
|||
|
|||
|
"Less Machining the better..."
Posted by Anton Abaya at 1/25/2001 10:36 PM EST
Coach on team #419, Rambots, from UMass Boston / BC High and NONE AT THE MOMENT! .In Reply to: i repeat the "i am a ninny" phrase... Posted by Anton Abaya on 1/25/2001 10:30 PM EST: : : So, is the general consensus that we should NOT use the 1/8" dowel provided by Small Parts? Any teams try this yet? : : Eric - 481 : i guess i need more experience with these set screws... : good info to know considering we were planning to screw the pins and go with the screws (did i confuse u there? ) hehe... : welll, we'll see what happens... : set screws=bad, pins=good? am i getting it? : -anton well, although machining is half the fun, we're not that luxurious to have access to one....so we try to manage as much as we can without having to customize stuff and using raw materials that we can fabricate using simple tools. I guess during heavy torque conditions slippage may happen with the set screws... fine fine... i'll pin the darn things... (1 or 2? hehe) -anton |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|