|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#4
|
|||
|
|||
|
see rambot...
Posted by Anton Abaya at 03/09/2001 1:31 AM EST
Coach on team #419, Rambots, from UMass Boston / BC High and If only we had free donuts.... In Reply to: Grooving wheelchair wheels Posted by Patrick Dingle on 03/08/2001 6:35 PM EST: hey there... if u look at our wheels, we actually spent time to put grooves in them. we used a router at the machine shop. it took an hour to do all 10 wheels! in the past, we used a utility knife to do it. it was the fastest solution. i've seen some using hacksaws, but that sucks. y dont u find some material that you can attach onto the outside of the wheels? i've seen some people put screws on the wheels. ive seen other wheels that have screwed RUBBER around it. (screwed rubber would be like those things u'd find underneath computer cases).. good luck though. -anton |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| wheelchair wheels | Stephen P | Technical Discussion | 2 | 02-02-2003 18:10 |
| Need 6" wheelchair wheels! | archiver | 2001 | 5 | 24-06-2002 03:08 |
| Lots of Wheels and F = u x N | archiver | 2001 | 17 | 23-06-2002 23:37 |
| has anyone ordered the wheelchair wheels outside of skyway? | archiver | 2001 | 0 | 23-06-2002 23:17 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |