|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
|
|||||
|
|||||
|
This was taken from a powerpoint that was given by Andy Baker (i think) at some Indiana FIRST Team thingy...
Gear and Sprocket Mounting -Trantorque (for medium to low loads) -collar clamp on a split hub -drill and tap through on a hub -dutchman's pin -weld -NEVER use set screws for this Gear or Sprocket to Wheel -skyway - pin wheel to large shaft, or capture spokes with a hub -using 3-4 holes, attach to wheel, close to perimeter |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Who used wheel encoders | CyberWolf_22 | Technical Discussion | 12 | 04-05-2003 15:37 |
| drill motor mounting | whynot | Technical Discussion | 3 | 03-02-2003 08:24 |
| new bosch pinion and mounting | ajlapp | Motors | 1 | 08-01-2003 17:16 |
| 3D Model of skyway 20" wheelchair wheel?? | Elgin Clock | 3D Animation and Competition | 2 | 14-09-2002 16:41 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |