|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
there is a set screw in the side of the pressure switch and ours leaks.... the screw was run in cross threaded and it ate up the hole.... if we just put some JB weld over the hold and plug it will it be OK? or do we have to order a new one?
![]() |
|
#2
|
|||
|
|||
|
Bullet
Order a new one!
Do Not USE! Presser behind that "plug" can shoot it out like a Bullet! ![]() |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| spike for pressure switch? | Rob Colatutto | Rules/Strategy | 4 | 23-02-2003 15:42 |
| pressure switch | Antonio | Pneumatics | 10 | 31-01-2003 03:52 |
| lost pressure switch | Josh Hambright | Pneumatics | 0 | 29-01-2003 08:30 |
| pressure switch | piconysm | Technical Discussion | 5 | 14-02-2002 23:15 |
| Error found in programming for the pump and pressure switch | sjharobotics | Programming | 4 | 06-02-2002 17:46 |