|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
I am here to annouce that I, Zachary Dobbin of Team 686 manganed to break one of our drill motors only 15 minutes after opening the kit of parts. I was looking at the drill gearbox with the motor and all of the suddent the drill motor fell out and landed on the table before rolling off and crashing onto the concrete floor. One of the leads fell out and some plastic cracked resulting in that motor becoming usless. Anyone else have problems this early in the season?
Last edited by ZacharyD : 04-01-2003 at 19:01. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| drill motor mounts- again | Jeff Sharpe | Motors | 6 | 07-04-2003 23:20 |
| drill motor mounting | whynot | Technical Discussion | 3 | 03-02-2003 08:24 |
| External metal jacket on the Drill motor and FP motor, WHY? | archiver | 2001 | 3 | 24-06-2002 04:22 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| Drill Motor and FP Motor Shaft Diameters | Andy Baker | Motors | 4 | 11-06-2001 20:12 |