|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Spike RED Pinout
I am using a Spike RED module for a project involving a demonstration, of electronic systems. I have searched everywhere, and haven't been able to get the pinout of the control pins for the Spike RED. Does anyone know of where I could find the pinout, or does anyone have it?
Otherwise, Im going to try to determine it experimentally, assuming the black wire is ground. Does a 5V signal as a test input the control pins seem reasonable? ![]() |
|
#2
|
|||
|
|||
|
Try putting a multimeter on the output of the RC to test what kind of output is going to the Spike. I would say they are PWM, but those are the analog outputs on the other side.
|
|
#3
|
||||
|
||||
|
Pin out is the same as the blue spike. Manual for blue spike is on Innovation First's site. I only have a hard copy for the red spike. If there is any info you need let me know.
|
|
#4
|
||||||
|
||||||
|
Andy, he was refering to the inputs from the RC, which the innovation FIRST manuals do not cover.
Venkatesh, you will find the answer in this thread: http://www.chiefdelphi.com/forums/sh...threadid=14026 When you first posted, I had remembered that thread, but couldn't find it. Well, now I finally found it. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| spike for pressure switch? | Rob Colatutto | Rules/Strategy | 4 | 23-02-2003 15:42 |
| Ok, so YOU design the 2003 game... | dlavery | General Forum | 157 | 07-01-2003 23:55 |
| Spike Relay Input | nwagers | Electrical | 3 | 16-07-2002 22:23 |
| Detroit Red Wings (NHL) | Matt Attallah | Chit-Chat | 36 | 16-06-2002 20:53 |
| Let's go red (and other seemingly random shoutouts) | Kyle Hill | Thanks and/or Congrats | 0 | 29-04-2002 13:08 |