|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
45 degree PVC angle fittings: which?
Posted by Joe Balint at 1/14/2001 1:05 AM EST
Engineer on team #537, Domo ARIGATO, from Sussex Hamilton HS and GE Medical Systems. For those who have manufactured the goals: I found two versions of the 45 degree PVC angle fittings. One is smooth (Ace HW part #43255) the other has a neck at it's center (Ace HW part #43131). Can anyone who examined this feature of the goals at Kick-off answer either of the following: 1) Which 45 degree PVC angle fittings are the correct ones; ACE HW #43255 smooth or #43131 necked? 2) What is the distance from inside one bend to the inside of one of the next bends around the perimeter? Basically, what is the length of one of the PVC octogon sides? WE have aproblem: It's obvious that the large ball (inflated to spec) sits much further down into our team's version of the goal then the large ball did at the goals at the Kick-off. Suprisingly enough, I can't find this dimension anywhere in the blueprint. Any help would be appreciated. -Joe |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PBASIC ARCTAN function | Greg Ross | Programming | 14 | 11-05-2003 12:28 |
| Is an angle bracket allowed? | archiver | 2001 | 0 | 24-06-2002 00:58 |
| Goal...PVC is loose... | archiver | 2001 | 7 | 23-06-2002 22:38 |
| pvc piping | gthakore | Rules/Strategy | 3 | 09-01-2002 21:27 |
| Valeo window motor | Mark Jones | Motors | 3 | 06-11-2001 16:47 |