|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||
|
|||
|
Re: 1/4" chain and links from small parts
Posted by Matt Berube at 2/5/2001 2:35 PM EST
Engineer on team #49, Delphi Knights, from Buena Vista High School and Delphi Automotive. In Reply to: 1/4" chain and links from small parts Posted by Alan Federman on 2/5/2001 1:43 PM EST: Yes, we had problems also. It seemed to me that the holes in the top plate (?) were too small for it to fit over the pins. I used our chain tool to press on a plate that I had removed from another link. It is working so far but that is because I haven't had to take it apart before. Matt B. T49 The Knights |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Chain and chain breaker source? | kmcclary | Off-Season Events | 4 | 22-10-2001 22:51 |