|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#10
|
||||
|
||||
|
Clarification - where along that line?
meaubry wrote:
> On the backside, away from the field we will be using L shaped angle aluminum brackets. OK. > You are correct in guessing corner to end of shelving unit. [If the bottle can fall through then slide it down further.] Where, slid along that line? Do we center the gap (equidistant space between top corner and shelving gap), or run it all the way to the top? Hmmm... On second thought, rather than have our mockup deviate from yours by just "setting a gap until it doesn't fall through", can you please just tell me what YOUR measurement is? Imagine a line on the divider board from the top left corner (top back edge) of the divider to the end of the shelf notch. Measure along that line from the top corner until you hit the center of thin edge of the backboard, which should be lying on that line. What is THAT length? Better yet (and easier to measure), what is the exact gap size?? Thanks! - Keith McClary, Huron High Team 830 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Serious Controller Ideas | archiver | 1999 | 28 | 23-06-2002 23:01 |