|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Robot reset on OI doesn't work
The Robot Reset switch on our Operator Interface doesn't appear to reset the Robot Controller. The only indication that I see on the RC is the Basic Init Err LED flashes for a moment approx every 3 times whan I press the reset switch. The Search/Tx, Valid Rx and Basic Run LEDs continue to flash.
The Reset switch on the Robot Controller operates normally, all LEDs on the RC go out except for Power On. Any ideas as to what's happening? |
|
#2
|
||||
|
||||
|
Quote:
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How much planning goes into your robot? | Jnadke | General Forum | 41 | 29-01-2006 21:29 |
| The Unnoficial Constitution - A Real Inspiration | sanddrag | Team Organization | 6 | 19-09-2003 15:40 |
| serious problem found - robot controller resets when jarred! | KenWittlief | Electrical | 23 | 19-03-2003 13:30 |
| WASH Palm scouting at the Championship | Mike Soukup | Scouting | 2 | 19-04-2002 15:14 |
| about how Drive Train push the robot... shouldn't the force accelerate the robot? | Ken Leung | Technical Discussion | 12 | 26-11-2001 09:39 |