|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
|||
|
|||
|
If you need any help with machining you can ask me. It's what I do
Most drill will drill through metal but you need to us lots of pressure. If you have a big drill say 3/8 or larger use a smaller drill first if helps out so you don't have to push as hard. As for speeds a good rule of thumb is start slow and crank up the speed until your flutes blur that about right. Or Smaller faster bigger slower ![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Svr... | Wetzel | Regional Competitions | 77 | 08-04-2003 13:01 |
| need/want some animation mentoring? | Soukup | 3D Animation and Competition | 69 | 18-02-2003 13:03 |
| For NYC FIRST teams who are mentoring FLL team... | Rich Wong | General Forum | 0 | 04-11-2002 16:01 |
| Roockie team mentoring | punarhero | Fundraising | 1 | 11-08-2002 20:34 |
| no more mentoring. | nick reynolds | General Forum | 7 | 27-09-2001 10:30 |