|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
|
||||
|
||||
|
I remember a similar problem. We were short a serial cable, and had to use a tether for programming, and sometimes we also got a Basic Init Error. All we did was turn off the robot, turn off the OI, push the cables in a little harder, turn both on, and pray. If it didn't work, rinse and repeat. When we went back to using the radios, everything was just fine.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Basic Run Error | BBFIRSTCHICK | Programming | 10 | 02-04-2003 22:43 |
| Wierd basic init | Jeremy J | Programming | 5 | 06-02-2003 11:42 |
| Basic Run Error | Ulibrium | Programming | 12 | 21-02-2002 01:02 |
| BASIC error | punarhero | Programming | 4 | 16-02-2002 23:21 |
| BASIC Stamp Error | mpatterson | Programming | 4 | 22-01-2002 12:08 |