|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
|
|||||
|
|||||
|
Hey Zach,
Most people wouldn't admit to dropping a part but we can all learn from your experience. Round parts do roll and gravity can't be ignored! Either work on a table with raised edges or work on the floor. Oh well, at least you get to take it apart and check out what's inside. What are the rivets in the case for? We are guessing they hold in the magnets. What is the guage of the armature wire? Well the big day is here, did anybody sleep last night? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| drill motor mounts- again | Jeff Sharpe | Motors | 6 | 07-04-2003 23:20 |
| drill motor mounting | whynot | Technical Discussion | 3 | 03-02-2003 08:24 |
| External metal jacket on the Drill motor and FP motor, WHY? | archiver | 2001 | 3 | 24-06-2002 04:22 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| Drill Motor and FP Motor Shaft Diameters | Andy Baker | Motors | 4 | 11-06-2001 20:12 |