|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Quote:
I was referring to the following lines not present in this years default program: p1_x = 127 'Port 1, X-axis on Joystick p2_x = 127 'Port 2, X-axis on Joystick p3_x = 127 'Port 3, X-axis on Joystick p4_x = 127 'Port 4, X-axis on Joystick p1_y = 127 'Port 1, Y-axis on Joystick p2_y = 127 'Port 2, Y-axis on Joystick p3_y = 127 'Port 3, Y-axis on Joystick p4_y = 127 'Port 4, Y-axis on Joystick p1_wheel = 127 'Port 1, Wheel on Joystick p2_wheel = 127 'Port 2, Wheel on Joystick p3_wheel = 127 'Port 3, Wheel on Joystick p4_wheel = 127 'Port 4, Wheel on Joystick 'p1_aux = 127 'Port 1, Aux Analog 'p2_aux = 127 'Port 2, Aux Analog 'p3_aux = 127 'Port 3, Aux Analog 'p4_aux = 127 'Port 4, Aux Analog It used to be directly below this: '---------- Initialize Inputs & Outputs -------------------------------------- Out7 = 1 'Basic Run LED on RC Out8 = 0 'PWM1 LED - Green Out9 = 0 'PWM1 LED - Red Out10 = 0 'PWM2 LED - Green Out11 = 0 'PWM2 LED - Red Out12 = 0 'Relay1 LED - Red Out13 = 0 'Relay1 LED - Green Out14 = 0 'Relay2 LED - Red Out15 = 0 'Relay2 LED - Green now its not there. I was wondering if I needed to add it or if the robot would run fine without it |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|