|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
I also believe it is software...
so make sure the software variables in the PBASIC code gets changed. Because below means that the default PBASIC code will do the following: the Full-Size RC Reference Guide says: for Pin 4 "PWM 3 won't go forward if rc_sw5 is ON" Pin 5 "PWM 3 won't go forward if rc_sw6 is ON" Pin 18 "PWM 4 won't go forward if rc_sw7 is ON" Pin 19 "PWM 4 won't go forward if rc_sw8 is ON" |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How much planning goes into your robot? | Jnadke | General Forum | 41 | 29-01-2006 21:29 |
| serious problem found - robot controller resets when jarred! | KenWittlief | Electrical | 23 | 19-03-2003 13:30 |
| How do u hook up the digital input to the sensor's wires | Fares | Technical Discussion | 2 | 14-02-2003 16:41 |
| WASH Palm scouting at the Championship | Mike Soukup | Scouting | 2 | 19-04-2002 15:14 |
| about how Drive Train push the robot... shouldn't the force accelerate the robot? | Ken Leung | Technical Discussion | 12 | 26-11-2001 09:39 |