|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
|
|||
|
|||
|
I'm already using all 8 of the PBASIC accessable LEDs on the OI. I want PBASIC access to the other three OI LEDS. Since they are hardwired to DI 1/2/3, I seek a way to switch those three DIs under program control. Hence my thought of wiring unused Relay Outputs to those three Digital Inputs. Thus, setting a relay out (under program control) switches the DI, resulting in control of the LED on the OI.
re: "some series resistance in the base circuit" - suggestions? couple hundred ohms? re: "See the IFI site for a .pdf file of the equivalent input circuit" - which file? I've pulled and reviewed most of them, and can't think what you might be referring to... re: "kind of output you have with the Banner sensors" - I'll check those docs out Thanks again! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How much planning goes into your robot? | Jnadke | General Forum | 41 | 29-01-2006 21:29 |
| serious problem found - robot controller resets when jarred! | KenWittlief | Electrical | 23 | 19-03-2003 13:30 |
| Robot Digital Input | Mike Norton | Technical Discussion | 5 | 16-01-2003 14:31 |
| WASH Palm scouting at the Championship | Mike Soukup | Scouting | 2 | 19-04-2002 15:14 |
| about how Drive Train push the robot... shouldn't the force accelerate the robot? | Ken Leung | Technical Discussion | 12 | 26-11-2001 09:39 |