|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
I don't see why you would do that...but no, I have not seen any rules saying you can't modify the output shaft
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hint #1 for Ken Leung | Shawn60 | General Forum | 35 | 11-02-2003 08:04 |
| chiaphua gear cluster | Antonio | Motors | 31 | 26-01-2003 20:04 |
| Securing hex shaft to drill output | D. Gregory | Technical Discussion | 6 | 24-01-2003 14:05 |
| Motor coupling | archiver | 2001 | 19 | 23-06-2002 23:35 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |