|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
||||
|
||||
|
There is also a method of locking the drill tranny into high gear by machining a steel (or HDPE) ring that fits inside of the transmission itself. If machining capabilities are available, this can prove to be a very effective method.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "Automatic Transmission" | Madison | Technical Discussion | 70 | 24-11-2003 09:03 |
| Disabling drill transmission clutch | Charlie B | Motors | 2 | 31-01-2003 10:02 |
| drill gearbox schematic? | Jeff Sharpe | Technical Discussion | 3 | 21-01-2003 00:18 |
| Locking the drill motor clutch? | Rick Gibbs | Motors | 1 | 06-01-2003 09:46 |
| Specs for drill motor gearbox? | archiver | 2000 | 4 | 23-06-2002 22:36 |