|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
||||||
|
||||||
|
To download code you need to
go to Parallaxinc.com and get the latest Stamp2 support software (V1.3 -- it is free) (download the latest Stamp2 manual while you are there) go to InnovationFirst.com to get the latest Default Code go to the whitepaper section of this websit to get my paper on Innovation First Hardware & the Default Code (the seminar should be online at the Nasa site by now, but I have not checked) look at the code and make chances you feel are needed connect your computer and the RC via a 9 pin connector download the code cross your fingers as you hit robot reset to run your code. ask us here specific questions as you run into problems. Good luck. Joe J |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming with the PBASIC Tokenizer | Raven_Writer | Programming | 12 | 05-01-2003 15:27 |
| PBasic Question | Melissa H. | Programming | 28 | 17-11-2002 18:53 |
| Programming the second joystick in PBASIC | archiver | 2001 | 2 | 24-06-2002 00:25 |
| Programming PBASIC for pneumatics | archiver | 2001 | 2 | 23-06-2002 23:58 |
| Simplifying PBasic | IDiggles | General Forum | 16 | 06-11-2001 01:36 |