|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
|
|||||
|
|||||
|
They probably got overheated too much and it just can't take that kind of stress. Drills usually don't cool exceptionally well, and over the course of a match, especially when the motor changes forward and reverse, they get darn hot. Especially if they aren't heatsinked. (I wish they'd include aluminum heatsinks in the kit...) Overheating and inadiquate cool-down time most likely killed your motors. At least that's my take on the issue. I could, as always, be completely off-base here.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Portable cordless drill press | Gui Cavalcanti | Technical Discussion | 25 | 03-08-2003 22:21 |
| drill motor mounts- again | Jeff Sharpe | Motors | 6 | 07-04-2003 23:20 |
| Emergency drill trade/sell | Anarkissed | General Forum | 3 | 16-02-2003 22:37 |
| Q&A Discuss: HOT drill motors | CD47-Bot | Extra Discussion | 1 | 27-01-2003 13:31 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |