|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
But to add to this... how are parts like these made in Inventor? Is there a good resource for learning the more advanced aspects of Inventor? I've been looking around, but haven't found any real good books...
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 25 or 35 chain? | Alan Ing | Technical Discussion | 24 | 02-03-2003 13:56 |
| 857 mostly complete robot | ajlapp | Robot Showcase | 24 | 12-02-2003 10:18 |
| Nylon Roller Chain Sprockets | Jim Smith | Technical Discussion | 6 | 20-01-2003 20:01 |
| 1/4" chain and links from small parts | archiver | 2001 | 2 | 24-06-2002 00:18 |
| Chain and chain breaker source? | kmcclary | Off-Season Events | 4 | 22-10-2001 22:51 |