|
|
|
![]() |
|
|||||||
|
||||||||
| View Poll Results: How much planning goes into your robot? | |||
| Drafting - None or very little pre-assembly planning - Hey, We're Optimistic. |
|
27 | 12.39% |
| Drafting - Moderate - Only essential systems are drawn up. |
|
94 | 43.12% |
| Drafting - Extreme - You could drive the robot before it's been built! |
|
73 | 33.49% |
| Calculations - None or very little - We live on the edge. |
|
18 | 8.26% |
| Calculations - Moderate - Yeah, we did a few to get some things right. |
|
107 | 49.08% |
| Calculations - Extreme - Is that an African or European Swallow? |
|
59 | 27.06% |
| Robot!?!? You mean we're supposed to be building a robot!? |
|
30 | 13.76% |
| Multiple Choice Poll. Voters: 218. You may not vote on this poll | |||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#27
|
||||
|
||||
|
Re: How much planning goes into your robot?
we normally draw up the essentials of the drive train and just go hacking away at the end effect. setup an end effect test it out, works - keep it, doesn't work - throw it out....start again.....make for a very proficient end effect, but gives little time for the drive train to be developed so we need to have the final drive train on the floor in very little time....
We normally know where we want to end up with our machine right after the kickoff weekend, but getting there is a little more tricky.... |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| serious problem found - robot controller resets when jarred! | KenWittlief | Electrical | 23 | 19-03-2003 13:30 |
| Image Discuss: 810 - Minotaur: Coming to a regional near you. | CD47-Bot | Robot Showcase | 47 | 25-02-2003 16:19 |
| WASH Palm scouting at the Championship | Mike Soukup | Scouting | 2 | 19-04-2002 15:14 |
| Index of team's post about their robot... | Ken Leung | Robot Showcase | 1 | 20-03-2002 17:10 |
| about how Drive Train push the robot... shouldn't the force accelerate the robot? | Ken Leung | Technical Discussion | 12 | 26-11-2001 09:39 |