|
Re: I Need Help with downloading Basic Stamp Program
Posted by Jerry Eckert, Engineer on team #140 from Tyngsboro, MA High School and New England Prototype/Brooks Automation.
Posted on 3/4/99 2:01 PM MST
In Reply to: Re: I Need Help with downloading Basic Stamp Program posted by Jeremy M. Husic on 3/4/99 11:59 AM MST:
: : I have modified the Basic Stamp program that comes with
: : the control box. When I use the command to send the
: : file alt R I keep getting the message.
: : "Hardware not found"
Another thing to check is that software is accessing the same serial port you have the cable connected to.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|