|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||
|
|||
|
3/8-24 & Left hand 10-24
Posted by Joe Johnson.   [PICTURE: SAME | NEW | HELP]
Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems. Posted on 1/26/2000 6:05 PM MST In Reply to: axle thread size posted by Shannon Schnepp on 1/26/2000 4:59 PM MST: I am 100% sure that the outside thread is a 3/8-24 -- see McMaster.com under drill chucks. They come standard in 3/8-24 thread. As to the inside thread, I am 95% that it is a left hand #10-24. BUT... I am also fairly sure that it is not a standard left hand thread. Something in my brain from days gone by tells me that it is a slightly enlarged thread. Anyway, you can buy left hand bolts from McMaster-Carr as well. Go to McMaster.com & find part number: 91670A245 HOWEVER, I think you will be much happier if you buy the proper screw from the Bosch Drill Service center. I have one on my desk at the office. I will get the part number and post it tomorrow -- remind me if I forget. Joe J. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The nostalgia thread or "Do you remember?" or All things old. | Elgin Clock | Chit-Chat | 128 | 06-11-2004 09:10 |
| Remember that thread? [08-19-03] | Ken Leung | General Forum | 5 | 23-08-2003 21:34 |
| Remember that thread? [08-04-03] | Ken Leung | General Forum | 6 | 06-08-2003 00:28 |
| Seeking a thread starter for Question of the week | Ken Leung | General Forum | 1 | 16-04-2003 12:52 |
| What was that thread? | sanddrag | CD Forum Support | 0 | 15-12-2002 12:01 |