|
Should be okay...
Posted by Joe Johnson.   [PICTURE: SAME | NEW | HELP]
Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.
Posted on 2/23/2000 2:32 PM MST
In Reply to: How is our gear ratio? posted by nuts4first on 2/23/2000 1:27 PM MST:
6 inch wheel, 70:1 ratio Should be okay. Fairly fast but not overly so, at least I don't think so.
If you do a lot of spinning you will tire the motors fast but other than that you should be okay, assuming that you have good bearings for your drive shafts & the chain routing is okay & etc.
Joe J.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|