|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||
|
|||
|
2 Specific Issues (at least in my mind)
Posted by Lora Knepper at 1/13/2001 8:02 AM EST
Other on team #419, Rambots, from UMass Boston / Boston College High School and Seeking Sponsorship. In Reply to: TANK TREADS...welp. Posted by Anton Abaya on 1/12/2001 10:50 PM EST: Anton, People may be nice enough to **help** us, but people aren't going to design this bot **for** us.... To all: We are exploring the use of tank treads on this year's bot...any one have thoughts? Pros? Cons? Suggestions? I drove a tank 'bot in '99 and there were a few problems that I'm not sure how to address in this one. Mainly speed and steering. The friction was so great when we'd turn that the timing belt would pop off frequently and the turning would often be painfully slow when driven like a tank with 2-joys. Also, there only seemed to be a point that we could push the drills to to power it, cutting our speed drastically. Would reducing the width of the tank treads help these issues? I have seen some decently fast and tight turning tank bots in past years...though I myself am a wheel girl all the way ;o) I'm not an engineer..not even close, though myself and Anton are about the closest to engineers this team has. Any insights would be greatly appreciated! ~ lora T419 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| tank treads vs. threaded wheels | lj8758 | Technical Discussion | 14 | 24-01-2003 00:30 |
| Under or Over? To tank or Not to tank that tis the question! | archiver | 2001 | 2 | 23-06-2002 22:53 |
| pneumatics tank | archiver | 2000 | 2 | 23-06-2002 22:43 |
| Filling the pneumatics tank | archiver | 2000 | 4 | 23-06-2002 22:43 |
| What problems have you encountered using treads? | M.I. | Technical Discussion | 8 | 15-01-2002 22:13 |