Go to Post I've worked with space based navigation and lever arms and planes and Kalman filters. .. and I have never, ever once considered looking up to navigate. - purduephotog [more]
Home
Go Back   Chief Delphi > Old Forum Archives > 2001
CD-Media   CD-Spy  
portal register members calendar search Today's Posts Mark Forums Read FAQ rules

 
 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
  #2   Spotlight this post!  
Unread 23-06-2002, 23:08
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
 
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
I'll allow it...

Posted by Joe Johnson at 1/17/2001 9:43 PM EST


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.


In Reply to: Can I drill the output shafts of unmodifiable motors?
Posted by CArobot on 1/17/2001 7:39 PM EST:



Not that it is up to me!

Yes, you are allowed to modify the output shafts of motors.

But...

Chief Delphi recommends against it if you can help it.

Why?

Because your motor may fail. If you need another, you
will either have to get more before hand (not always
easy, or cheap or even possible). If you cannot modify
some spares before hand, then you will have to make a
feild modification with a motor from FIRST obtained
when you turn in your broken motor. This can be very
tricky.

So... if you can get away without having to modify your
output shafts or can utilize easily made modifications,
you will be ahead in the long run.

Joe J.

P.S. You are not allowed to take apart the motors with
worm drives in order to pull power directly from the
armature rather than going through the (relatively)
inefficient worm drives.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
 


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Speed Reduction for Drill Motors Ian W. Programming 5 18-01-2003 23:57
Complete Drill, Seat, and Window motors for trade archiver 2000 0 23-06-2002 22:16
Complete Drill, Seat, and Window motors for trade archiver 2000 0 23-06-2002 22:16
"Motors and Drive train edition" of Fresh From the Forum Ken Leung CD Forum Support 6 29-01-2002 12:32
what about the drill motors? Ken Leung Motors 2 26-06-2001 02:11


All times are GMT -5. The time now is 11:23.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi