Go to Post I'm sure there aren't a bunch of rule makers sitting in a board room discussing "What rule can we change now to mess with the teams' heads?" Lets all just sit back and enjoy the regionals! - Rick [more]
Home
Go Back   Chief Delphi > Old Forum Archives > 2001
CD-Media   CD-Spy  
portal register members calendar search Today's Posts Mark Forums Read FAQ rules

 
 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
  #3   Spotlight this post!  
Unread 23-06-2002, 23:26
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
 
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: they are supposed to

Posted by james at 1/22/2001 6:26 PM EST


Coach on team #694, PULSE, from stuyvesant high school and AOL Time Warner.


In Reply to: they are supposed to
Posted by Ken Leung on 1/22/2001 5:34 PM EST:



asked the wrong question i guess. the sprocket doesn't fit the way it's diagrammed. the wheel hub fits, but according to the diagram, the sprocket then goes on after that. the sprockets bore sizes are 3/8, 1/2 etc, but the diagram shows it fitting on the wheel which is around 1". to fit a sprocket on the hub, do we have to mill the sprocket?

thanks for answering.

james ng
p.s...where are you guys from?


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
 


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
plastic hubs and drill motors Will Camisa General Forum 4 01-03-2003 00:03


All times are GMT -5. The time now is 14:36.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi