|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
|||
|
|||
|
Re: would muffin fans make the difference?
Posted by Matt Leese at 1/26/2001 10:37 AM EST
Other on team #73, Tigerbolt, from Edison Technical HS and Alstom & Rochester Institute of Technology. In Reply to: would muffin fans make the difference? Posted by Anton Abaya on 1/26/2001 8:51 AM EST: Muffin fans won't SOLVE the problem. If you're burning up lots of drills or gearboxes you've got a mechanical problem on your hands (remember it's never the EE's or CE's fault . Installing Muffin fans will however help to cool the motors some. If the gearboxes are getting hot enough to melt the Muffin fan can't put out enough air to cool them that much. However, if they're heating up from general wear and tear than the Muffin fan can help a bit. So basically the Muffin fan can help but won't solve your problem.Matt |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Portable cordless drill press | Gui Cavalcanti | Technical Discussion | 25 | 03-08-2003 22:21 |
| drill motor mounts- again | Jeff Sharpe | Motors | 6 | 07-04-2003 23:20 |
| Emergency drill trade/sell | Anarkissed | General Forum | 3 | 16-02-2003 22:37 |
| Q&A Discuss: HOT drill motors | CD47-Bot | Extra Discussion | 1 | 27-01-2003 13:31 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |