|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#5
|
|||
|
|||
|
Re: Grooving wheelchair wheels
Posted by Dan at 03/09/2001 6:08 AM EST
Other on team - from Carnegie Mellon sponsored by -. In Reply to: Grooving wheelchair wheels Posted by Patrick Dingle on 03/08/2001 6:35 PM EST: I'm not sure what the rules are, but I found some awesome cogged v-belt that has some huge teeth. It's not timing belt, but it looks like it. It's cogged so it has a smaller min. bend radius. Check out www.mscdirect.com. It's also a good way to add to your wheel diameter for speed (I found 1/2" thick and 7/8" wide belts.) Dan |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| wheelchair wheels | Stephen P | Technical Discussion | 2 | 02-02-2003 18:10 |
| Need 6" wheelchair wheels! | archiver | 2001 | 5 | 24-06-2002 03:08 |
| Lots of Wheels and F = u x N | archiver | 2001 | 17 | 23-06-2002 23:37 |
| has anyone ordered the wheelchair wheels outside of skyway? | archiver | 2001 | 0 | 23-06-2002 23:17 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |